IN PROGRESS: Cat Treats Dispenser
— more info coming soon — Remote Treat Dispenser Sends You Adorable Photos of Your Pet Video
JD-X Project: Experimental Setup
— more info coming soon —
Lasercut Lamp Shade
Needed a new lampshade, and I finally found the time to work on this idea. It turned out quite well. I made the living hinge a bit stiff and bending was difficult. If I redo it, I would make the hinge softer.
Lasercut Napkin Holder
Needed a napkin holder for my new place. Designed with a pattern to match the lamp shade, which is coming soon.
Lasercut Interlocking Coasters
I had to go to a birthday party and as typical for me, decided that a hand-made gift would be more valuable. I got the idea from a different type of interlocking coasters I had seen a while ago. I drafted the 2D drawing in OnShape. The coasters were cut and engraved from 5mm thick…
3D Printer Upgrades: Remote Command Center, Thermal Protection and More
I have been printing a lot lately. Mostly parts and molds needed for my Master’s Thesis, as well as gifts and such. Ever since I got my second 3D printer, I have been using a RaspberryPi running OctoPrint (which is just WONDERFUL!). For those that are not familiar with it, Octoprint is essentially a gcode…
DIY Silicone Casting Tools: “The Slammer” (a.k.a. “The Tapper” v2.0)
— more info coming soon — Video testing
DIY Silicone Casting Tools – “The Tapper”
— more info coming soon — Testing In action
My 3D Printers: Tevo Tarantula and Monoprice Maker Select v2.1
Tevo Tarantula (kit) I was tired of running to the HackRSpace and Makerspace all the time and knowing that I had to do a lot more 3D printing for my Master’s Thesis, I finally pulled the trigger and ordered the very well-reviewed Tevo Tarantula 3D printer kit for about $200. Most of the 3D printers…